Nissan Sentra Owners Manual: Starting and driving
- Precautions when starting and driving
- Exhaust gas (carbon monoxide)
- Three-way catalyst
- Tire Pressure Monitoring System (TPMS)
- Avoiding collision and rollover
- Off-road recovery
- Rapid air pressure loss
- Drinking alcohol/drugs and driving
- Ignition switch (if so equipped)
- Continuously Variable Transmission (CVT) (if so equipped)
- Manual transmission (if so equipped)
- Key positions
- NISSAN vehicle immobilizer system
- Push-Button Ignition Switch (if so equipped)
- Operating range
- Push-button ignition switch positions
- Emergency engine shut off
- NISSAN Intelligent Key® battery discharge
- NISSAN vehicle immobilizer system
- Before starting the engine
- Starting the engine
- Starting the engine (models with NISSAN Intelligent Key® system)
- Driving the vehicle
- Parking brake
- SPORT mode switch
- ECO mode switch
- Cruise control (if so equipped)
- Break-in schedule
- Fuel efficient driving tips
- Increasing fuel economy
- Parking/parking on hills
- Power steering
- Brake system
- Vehicle Dynamic Control (VDC) system
- Cold weather driving
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
follow the solutions given in this guide
for the appropriate error. Where the solutions ar ...
Precautions when starting and driving
WARNING
Do not leave children or adults who
would normally require the assistance
of others alone in your vehicle. Pets
should also not be left alone. They
could accidentall ...
Other materials:
Adjustment of steering angle sensor neutral position
Description
Refer to the table below to determine if adjustment of steering
angle sensor neutral position is required.
×: Required –: Not required
Work Procedure
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
CAUTION:
To adjust neutral position of steering angle sensor, ...
C1601 Battery power supply
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1601
BATTERY VOLT
When a power supply voltage to the EPS control unit
is maintained at 17.5 V or more or at less than 9 V
continuously for five second or more.
...
Evaporative emission system
EVAPORATIVE EMISSION SYSTEM : System Description
SYSTEM DIAGRAM
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed*
EVAP canister
purge flow control
EVAP canister purge volume
control ...
