Nissan Sentra Service Manual: Can system (type 3)
Dtc/circuit diagnosis
- Main line between ipdm-e and dlc circuit
- Main line between dlc and av circuit
- Ecm branch line circuit
- Abs branch line circuit
- Ipdm-e branch line circuit
- Tcm branch line circuit
- A-bag branch line circuit
- Dlc branch line circuit
- Eps branch line circuit
- M&a branch line circuit
- Strg branch line circuit
- AV branch line circuit
- Bcm branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis procedure
1.Connector inspection
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on can communication syste ...
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and ...
Other materials:
S terminal circuit
Description
The output voltage of the generator is controlled by the IC regulator at
terminal “S” detecting the input voltage
from battery.
The “S” terminal circuit detects the battery voltage to adjust the generator
output voltage with the IC voltage
regulator.
Diagn ...
Fuel pressure
Work Procedure
FUEL PRESSURE RELEASE
1.FUEL PRESSURE RELEASE
With CONSULT
Turn ignition switch ON.
Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using
CONSULT
Start engine.
After engine stalls, crank it two or three times to release ...
Floor mats
WARNING
To avoid potential pedal interference that
may result in a collision or injury:
NEVER place a floor mat on top of another
floor mat in the driver front
position.
Use only genuine NISSAN floor mats
specifically designed for use in your vehicle
model. See ...
