Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Nissan Sentra Service Manual / Engine / Engine mechanical / Removal and installation

Compression pressure
Inspection Warm up the engine to full operating temperature. Release fuel pressure. Refer to EC-143, "Work Procedure". Remove ignition coil and spark plug from each cylinder. Refer t ...

Engine room cover
Exploded View Engine room cover Mounting rubber (Black) Mounting rubber (Gray) Removal and Installation REMOVAL CAUTION: Do not damage or scratch engine room cover when installing o ...

Other materials:

SPORT mode switch
Adjusts the throttle sensitivity and transmission points (CVT only) to enhance performance. Press the SPORT button on the instrument panel to activate. The SPORT mode indicator light (on the speedometer) will illuminate. The SPORT mode indicator light will remain lit while the mode is acti ...

Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final tightening with grounded and unloaded vehicle condition, and then check wheel alignment. Observe the following precautions when disassembling. Before disassembly, thoroughly clean the outside of the unit. ...

Low tire pressure warning lamp
Component Function Check 1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON. Is the inspection result normal? YES >> Inspection ...

В© 2014-2026 Copyright www.nisentra.com