Nissan Sentra manuals

Nissan Sentra Service Manual: Ignition coil

Exploded View


  1. Ignition coil
  2. Spark plug
  3. Rocker cover

Removal and Installation

REMOVAL

  1. Remove the engine room cover. Refer to EM-24, "Exploded View".
  2. Disconnect the harness connector from the ignition coil.
  3. Remove the ignition coil.

CAUTION:

Do not drop or shock it.

INSTALLATION

Installation of remaining components is in the reverse order of removal.

Fuel injector and fuel tube
Exploded View Bracket Fuel tube bracket Fuel feed tube Quick connector cap Fuel tube O-ring (black) Fuel injector O-ring (green) Injector clip CAUTION: Do not remove or dis ...

Rocker cover
Exploded View Oil filler cap Rocker cover protector Oil filler tube O-ring Rocker cover Rocker cover gasket Refer to INSTALLATION Removal and Installation REMOVAL Remo ...

Other materials:

Locking with power door lock switch
Door lock switch To lock all the doors without a key, push the door lock switch (driver’s or front passenger’s side) to the lock position 1 . When locking the door this way, be certain not to leave the key inside the vehicle. To unlock all the doors without a key, push the door lock ...

Locking with key
Driver’s side The power door lock system allows you to lock or unlock all doors at the same time. Turning the key toward the front 1 of the vehicle locks all doors. Turning the key one time toward the rear 2 of the vehicle unlocks that door. From that position, returning the key to ...

P050A, P050B, P050E Cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A, P050B or P050E ...

© 2014-2026 Copyright www.nisentra.com