Nissan Sentra manuals

Nissan Sentra Owners Manual: Help voice commands

Nissan Sentra Owners Manual / Monitor, climate, audio, phone and voice recognition systems / NISSAN Voice Recognition System (if so equipped) / Help voice commands

The following voice commands can be spoken to have the system provide instructions and tips for using the NISSAN Voice Recognition system.

Symptom/error message

 Solution
The system responds “Command Not Recognized” or the system fails to recognize the command correctly.
  1. Ensure that the command format is valid. Use the “List Commands” or “What Can I Say?” command under the “Help” menu.
  2. Speak clearly without pausing between words and at a level appropriate to the ambient noise level.
  3. Ensure that the ambient noise level is not excessive (for example, with the windows open or the defroster on).

NOTE:

If it is too noisy to use the phone, it is likely that voice commands will not be recognized.

  1. If optional words of the command have been omitted, then the command should be tried with these in place.
Information voice commands
The following voice commands are available for the information functions of the Navigation System: Traffic Fuel Prices Stocks Movie Listings Current Weather Weather Map 5 — day Fore ...

Troubleshooting guide
The system should respond correctly to all voice commands without difficulty. If problems are encountered, follow the solutions given in this guide for the appropriate error. Where the solutions ar ...

Other materials:

Dtc/circuit diagnosis
U1000 can comm circuit Description Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Dtc logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic sym ...

Ignition coil
Exploded View Ignition coil Spark plug Rocker cover Removal and Installation REMOVAL Remove the engine room cover. Refer to EM-24, "Exploded View". Disconnect the harness connector from the ignition coil. Remove the ignition coil. CAUTION: Do not drop or shock i ...

Clutch pedal
Inspection and Adjustment INSPECTION The Height of Clutch Pedal Pull back the floor trim and remove front floor spacer (LH) for access to floor panel. Check that the clutch pedal height (H1) from the floor panel (1) is within the reference value. Clutch pedal height (H1) Replace ...

© 2014-2026 Copyright www.nisentra.com