Nissan Sentra Owners Manual: Audio system
- Radio
- FM radio reception
- AM radio reception
- Satellite radio reception (if so equipped)
- Audio operation precautions
- FM/AM radio with compact disc (CD) player (if so equipped)
- FM/AM/SAT radio with compact disc (CD) player (Type A) (if so equipped)
- FM/AM/SAT radio with compact disc (CD) player (Type B) (if so equipped)
- USB interface (models without Navigation System) (if so equipped)
- USB interface (models with Navigation System)
- iPod®* player operation without Navigation System (if so equipped)
- iPod®* player operation with Navigation System (if so equipped)
- Bluetooth® streaming audio without Navigation System (if so equipped)
- Bluetooth® streaming audio with Navigation System (if so equipped)
- Pandora® audio (if so equipped)
- CD care and cleaning
- Steering wheel switch for audio control (if so equipped)
- Antenna
Servicing air conditioner (if so equipped)
The air conditioner system in your NISSAN vehicle
is charged with a refrigerant designed with
the environment in mind.
This refrigerant does not harm the earth’s
ozone layer.
Special charging e ...
Radio
With the ignition placed in the ACC or ON position,
press the PWR (power)/VOL (volume) knob
to turn the radio on. If you listen to the radio with
the engine not running, the ignition should be
pla ...
Other materials:
USB interface (models with Navigation System)
Connecting a device to the USB input
jack
WARNINGDo not connect, disconnect, or operate the
USB device while driving. Doing so can be
a distraction. If distracted you could lose
control of your vehicle and cause an accident
or serious injury.
CAUTION
Do not force t ...
Power supply and ground circuit
WITH INTELLIGENT KEY SYSTEM
WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-51, "Wiring Diagram".
1.Check fuses and fusible link
Check that the following fuses and fusible link are not blown.
Is the fuse blown?
Yes >> r ...
General Precautions
Always use a 12 volt battery as power source.
Do not attempt to disconnect battery cables while engine is
running.
Before connecting or disconnecting the ECM harness connector,
turn ignition switch OFF and disconnect negative battery
cable. Failure to do so may damage the ECM because
...
