Nissan Sentra B18 (2020-2025) Service Manual / Driver Controls / Exterior Lighting System :: Halogen Headlamp / Dtc/circuit Diagnosis / Tail Lamp

Nissan Sentra B18 (2020-2025) Service Manual: Tail Lamp

Component Inspection

Component Inspection

CHECK TAIL LAMP 1

Ignition switch OFF.
Disconnect each rear combination lamp connector.

Check continuity between each rear combination lamp terminals.

Body side
Rear combination lamp (body side)		Continuity
Terminals		Continuity
2	4	Yes

Trunk lid side
Rear combination lamp (trunk lid side)		Continuity
Terminals		Continuity
1	4	Yes

Is the inspection result normal?

YES>>

GO TO 2.

NO >>

Rear combination lamp (body side): Replace corresponding rear combination lamp (body side) bulb. Refer to Bulb Replacement.

NO >>

Rear combination lamp (trunk lid side): Replace corresponding rear combination lamp (trunk lid side) bulb. Refer to Removal and Installation.

CHECK TAIL LAMP 2

Remove tail lamp bulb.

Check continuity between each rear combination lamp terminals.

Body side
Rear combination lamp (body side)		Continuity
Terminals		Continuity
2	4	No

Trunk lid side
Rear combination lamp (trunk lid side)		Continuity
Terminals		Continuity
1	4	No

Is the inspection result normal?

YES >>

Inspection End.

NO >>

Repair or replace each rear combination lamp bulb socket or harness.

 Turn Signal Lamp

Component Inspection Component Inspection CHECK TURN SIGNAL LAMP Ignition switch OFF. Disconnect front combination lamp connector, rear combination lamp (body side) connector an...

 License Plate Lamp

Component Inspection Component Inspection CHECK LICENSE PLATE LAMP 1 Ignition switch OFF. Disconnect license plate lamp connector. Check continuity between license plate lamp te...

Other materials:

Trip computer
1. Vehicle speed The vehicle speed screen shows the current speed of the Nissan Sentra as well as the average vehicle speed calculated since the last reset. Average vehicle speed: Press the OK button on the steering wheel to open the drive computer Reset menu, then follow the on-screen in ...

6m/t
Exploded View (lh) Exploded View (LH) 1. Circular clip 2. Slide joint housing 3. ...

Removal and Installation. 8ch Can Gateway
8ch Can Gateway Removal and Installation Removal and Installation CAUTION: If replacing 8CH CAN gateway, Perform "ADDITIONAL SERVICE WHEN REPLACING 8CH CAN GATEWAY". Refer to Work Procedure. REMOVAL Remove instrument panel assembly. Refer to Removal and Installation ...