Nissan Sentra B18 (2020-2025) Service Manual: Turn Signal Lamp
Component Inspection
-
CHECK TURN SIGNAL LAMP
-
-
Ignition switch OFF.
-
Disconnect front combination lamp connector, rear combination lamp (body side) connector and door mirror connector.
-
Check continuity between each lamp terminals.
Front turn signal lamp Front combination lamp
Continuity
Terminals
4
2
Yes
Rear turn signal lamp Rear combination lamp (body side)
Continuity
Terminals
1
4
Yes
Side turn signal lamp (with Intelligent Around View® Monitor system) Rear combination lamp (body side)
Continuity
Terminals
11
12
Yes
Side turn signal lamp (without Intelligent Around View® Monitor system) Rear combination lamp (body side)
Continuity
Terminals
1
5
Yes
-
Is the inspection result normal?
YES >>GO TO 2.
NO >>Front turn signal lamp: Replace corresponding front combination lamp bulb. Refer to Bulb Replacement.
NO >>Rear turn signal lamp: Replace corresponding rear combination lamp (body side) bulb. Refer to Bulb Replacement.
NO >>Side turn signal lamp: Replace corresponding door mirror turn signal lamp. Refer to Removal and Installation.
-
-
CHECK TURN SIGNAL LAMP BULB SOCKET AND HARNESS
-
-
Remove turn signal lamp bulb.
-
Check continuity between each lamp terminals.
Front turn signal lamp Front combination lamp
Continuity
Terminals
4
2
No
Rear turn signal lamp Rear combination lamp (body side)
Continuity
Terminals
1
4
No
-
Is the inspection result normal?
YES >>Inspection End.
NO >>Repair or replace the turn signal lamp bulb socket or harness.
-
Parking Lamp
Component Inspection
Component Inspection
CHECK PARKING LAMP
Ignition switch OFF.
Disconn ...
Other materials:
Basic inspection
Component inspection
Inspection
AFTER A COLLISION
WARNING:
Inspect all seat belt assemblies including retractors and attaching
hardware after any collision.
NISSAN/INFINITI recommends that all seat belt assemblies in use during a
collision be replaced
unless the collision was minor and t ...
ID registration procedure
Description
This procedure must be performed after replacing wheels, transmitters or the
BCM, or rotating wheels.
Work Procedure
TPMS ID registration can be performed using one of the following procedures:
Transmitter Activation tool (J-45295-A) with CONSULT (preferred method)
Signal Tec ...
Trunk Side Finisher
Removal and Installation
Removal and Installation
REMOVAL
Remove
trunk rear plate. Refer to Removal and Installation.
Remove rear
seat bolster. Refer to Removal and Installation — Rear Seat
Bolster.
Position
rear seatback forward.
Using a
suitable tool, re ...
