Nissan Sentra B18 (2020-2025) Service Manual: Parking Lamp
Component Inspection
-
CHECK PARKING LAMP
-
-
Ignition switch OFF.
-
Disconnect front combination lamp connector.
-
Check continuity between front combination lamp terminals.
Front combination lamp
Continuity
Terminals
1
2
Yes
-
Is the inspection result normal?
YES >>Inspection End.
NO >>Replace corresponding front combination lamp bulb. Refer to Bulb Replacement.
-
Turn Signal Lamp
Component Inspection
Component Inspection
CHECK TURN SIGNAL LAMP
Ignition switch OFF.
Dis ...
Other materials:
Around View Monitor Control Unit
Removal and Installation
Removal and Installation
REMOVAL
CAUTION:
When replacing around view monitor control unit,
perform "ADDITIONAL SERVICE WHEN REPLACING AROUND VIEW MONITOR
CONTROL UNIT". Refer to Description.
Remove
passenger side seat. Refer to Removal ...
Can communication circuit
Diagnosis procedure
1.Connector inspection
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on CAN communication system.
Check terminals and connectors for damage, bend and loose connection.
Is the inspection resu ...
Removal and installation
Generator
Exploded view
Thermostat housing
Generator bolt (upper)
Generator bolt (lower)
Generator
B” terminal harness
“B” terminal nut
Generator harness connector
Front
Removal and installation
Note:
When removing components such as hoses,tubes\lines,etc,ca ...
