Nissan Sentra Service Manual: Removal and installation

Front fog lamp

Aiming adjustment PREPARATION BEFORE ADJUSTING The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming adjustment procedure, check the following: ...

Front combination lamp

Exploded view Large cover (not serviceable) Small cover (not serviceable) Front combination lamp Halogen lamp bulb (high beam) Turn signal lamp bulb Turn signal lamp bulb socket ...

Other materials:

P0643 Sensor power supply
Description ECM supplies a voltage of 5.0 V to some of the sensors systematically divided into 2 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the shorted-circui ...

Evaporative emission system
Inspection EVAP CANISTER 1.CHECK EVAP CANISTER Block port (B). Blow air into port (A) and check that it flows freely out of port (C). Release blocked port (B). Apply vacuum pressure to port (B) and check that vacuum pressure exists at the ports (A) and (C). Block port (A) and (B). ...

Oil seal
Valve oil seal : Removal and Installation REMOVAL Rotate crankshaft, and set piston whose valve oil seal is to be removed to TDC. This will prevent valve from dropping into cylinder. CAUTION: When rotating crankshaft, be careful to avoid scarring front cover with timing chain. Re ...