Nissan Sentra manuals

Nissan Sentra Service Manual: Door mirror turn signal lamp

Removal and installation

The door mirror side turn signal lamp is integrated into the door mirror assembly and is serviced as an assembly.

Refer to MIR-18, "Exploded View".

Front fog lamp
Removal and Installation FOG LAMP Removal Position the fender protector aside. Refer to EXT-28, "FENDER PROTECTOR : Removal and Installation - Front Fender Protector". Disconnec ...

High-mounted stop lamp
Removal and Installation HIGH-MOUNTED STOP LAMP - WITH REAR SPOILER Removal Remove the rear air spoiler. Refer to EXT-46, "Removal and Installation". Remove the screws and the h ...

Other materials:

Sensor rotor
Front sensor rotor FRONT SENSOR ROTOR : Removal and Installation The front wheel sensor rotor is an integral part of the wheel hub and bearing assembly and cannot be disassembled. Refer to FAX-8, "Removal and Installation". Rear sensor rotor REAR SENSOR ROTOR : Removal and Install ...

Map lamp
Removal and installation Removal Lower front edge of map lamp (1) down from the headlining by releasing the metal clips, then slide forward to clear pawls at rear. : Metal clip Pawl Disconnect the harness connectors from the map lamp and remove. Installation Installation is in t ...

Precautions for Suspension
When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil. Unladen conditions mean that fuel, engine coolant and lubricant are ...

В© 2014-2025 Copyright www.nisentra.com