Nissan Sentra Service Manual: Front fog lamp
Removal and Installation
FOG LAMP
Removal
- Position the fender protector aside. Refer to EXT-28, "FENDER PROTECTOR : Removal and Installation - Front Fender Protector".
- Disconnect the harness connector from the front fog lamp.
- Remove the screws and the front fog lamp.
Installation
Installation is in the reverse order of removal.
NOTE:
After installing, perform fog lamp aiming adjustment. Refer to EXL-117, "Aiming Adjustment".
FRONT FOG LAMP BULB
Removal
WARNING:
Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.
CAUTION:
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Do not leave the bulb out of the lamp reflector for a long time
because dust, moisture, smoke, etc.
may affect the performance of the lamp.
- Position the front fender protector aside. Refer to EXT-28, "FENDER PROTECTOR : Removal and Installation - Front Fender Protector".
- Disconnect the harness connector from the front fog lamp bulb.
- Rotate the front fog lamp bulb socket counterclockwise and remove.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.
Revision:
Front combination lamp
Exploded view
Large cover (not serviceable)
Small cover (not serviceable)
Front combination lamp
Halogen lamp bulb (high beam)
Turn signal lamp bulb
Turn signal lamp bulb socket
...
Door mirror turn signal lamp
Removal and installation
The door mirror side turn signal lamp is integrated into the door mirror
assembly and is serviced as an assembly.
Refer to MIR-18, "Exploded View". ...
Other materials:
B0028 Side airbag module RH
Description
DTC B0028 FRONT RH SIDE AIR BAG MODULE
The front RH side air bag module is wired to the air bag diagnosis sensor
unit. The air bag diagnosis sensor
unit will monitor for opens and shorts in detected lines to the front RH side
air bag module.
PART LOCATION
Refer to SRC-5, " ...
System
Body control system
Body control system : system description
OUTLINE
BCM (Body Control Module) controls the various electrical components. It
inputs the information required to
the control from CAN communication and the signal received from each switch
and sensor.
BCM has combination ...
C1111 PUMP MOTOR
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1111
PUMP MOTOR
When a malfunction is detected in motor or motor
relay.
When a low pressure malfunction is detected in accumulator.
When a malfunction ...
