Nissan Sentra Service Manual: Hazard switch
Removal and Installation
REMOVAL
- Remove cluster lid C (1). Refer to IP-20, "Removal and Installation - Cluster Lid C".
- Release pawls at ( ) and remove hazard switch (2).
INSTALLATION
Installation is in the reverse order of removal.
Combination switch
Exploded view
Combination switch
Combination switch harness connector
Front
NOTE:
Shown with the steering wheel removed for clarity only.
Removal and installation
REMOVAL
CAUTION:
...
Optical sensor
Removal and installation
REMOVAL
Remove the defroster grille (LH) using a suitable tool.
Disconnect the harness connector from the optical sensor.
Release the pawls and remove the optical sen ...
Other materials:
A-bag branch line circuit
Diagnosis procedure
Warning:
Always observe the following items for preventing accidental
activation.
Before servicing, turn ignition switch off, disconnect battery
negative terminal, and wait 3 minutes
or more. (To discharge backup capacitor.)
Never use unspecified tester or other me ...
Unit disassembly and assembly
Moonroof unit assembly
Exploded view
Drain assembly
Glass lid
Weatherstrip
Moonroof rail assembly
Drain hose front (RH)
Moonroof motor assembly
Drain hose front (LH)
Side bracket (LH)
Drain hose rear (LH)
Sunshade stopper (LH)
Sunshade
Sunshade stopper (RH)
Drain hos ...
Low tire pressure warning lamp blinks
Diagnosis Procedure
NOTE:
If low tire pressure warning lamp repeats blinking ON for 2 seconds and
OFF for 0.2 seconds, wake-up operation
for all transmitters is not complete.
Carry out transmitter wake-up operation. Refer to WT-22, "Work Procedure".
1.CHECK BCM CONNECTOR
Turn ...
