Nissan Sentra B18 (2020-2025) Service Manual: P17f2-07 Cvt Judder (t/c Inspection)

Nissan Sentra B18 (2020-2025) Service Manual / Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f15a / Dtc/circuit Diagnosis / P17f2-07 Cvt Judder (t/c Inspection)

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC		CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P17F2	07	CVT JUDDER (T/C INSPECTION) [CVT judder (Torque Converter Inspection)]	Diagnosis condition	—
			Signal	—
			Threshold	Malufunction in torque converter
			Diagnosis delay time	—

POSSIBLE CAUSE

Torque converter

FAIL-SAFE

Not changed from normal driving

DTC CONFIRMATION PROCEDURE

CAUTION:

Be careful of the driving speed.

CHECK DTC DETECTION

With CONSULT
1. Start the engine.
2. With the accelerator pedal position 1/8, accelerate the Nissan Sentra vehicle from 0 km/h (0 MPH) to 50 km/h (31 MPH).
3. Drive the vehicle at 50 km/h (31 MPH) constant speed for 15 seconds.
4. Stop the Nissan Sentra vehicle with a brake force which allows the vehicle to stop in 10 to 20 seconds.
5. Repeat steps 2 to 4 above 5 times.
6. Check the DTC.
Is "P17F2-07" detected?
YES >>
Go to DTC Diagnosis Procedure.
NO-1>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>
Confirmation after repair: INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

REPLACE TORQUE CONVERTER
1. Remove transaxle assembly. Refer to Removal and Installation.
2. Replace torque converter. Refer to Disassembly and Assembly.
>>
WORK END

P187e-09 T/m System Malfunction

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms ( ...

Other materials:

Blower Motor
Diagnosis Procedure Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check 30A fuse [No. 55, located in fuse block (J/B)]. ...

Removal and Installation
Removal and Installation REMOVAL CAUTION: Do not cause impact to steering column during removal and installation. Do not move steering gear during removal and installation of steering column. Set the front ...

Basic inspection
Component inspection Inspection AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and t ...