Nissan Sentra B18 (2020-2025) Service Manual / Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f15a / Dtc/circuit Diagnosis / P0960-00 Pressure Control Solenoid a

Nissan Sentra B18 (2020-2025) Service Manual: P0960-00 Pressure Control Solenoid a

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC		CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0960	00	PC SOLENOID A (Pressure Control Solenoid "A" Control Circuit/Open)	Diagnosis condition	Power supply voltage ≥ 10 V
			Signal	Line pressure solenoid valve drive signal
			Threshold	Solenoid valve drive circuit is diagnosed as open
			Diagnosis delay time	0.2 seconds

POSSIBLE CAUSE

Harness or connector
Line pressure solenoid valve
TCM

FAIL-SAFE

Lock-up is not performed
Stop/start system prohibited

DTC CONFIRMATION PROCEDURE

PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V.

>>
GO TO 2.
CHECK DTC DETECTION
1. Start the engine and wait for 5 seconds or more.
2. Check the DTC.
Is "P0960-00" detected?
YES >>
Proceed to Diagnosis Procedure.
NO-1>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>
Confirmation after repair: INSPECTION END

Diagnosis Procedure

Diagnosis Procedure

CHECK LINE PRESSURE SOLENOID VALVE CIRCUIT

Check line pressure solenoid valve circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?
YES>>
Replace TCM. Refer to Removal and Installation.
NO >>
Repair or replace damaged parts.

 P0890-00 Tcm

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0890 00 TCM (Transmission Control Module Power ...

 P0961-00 Pressure Control Solenoid a

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0961 00 PC SOLENOID A (Pressure Control Solenoi...

Other materials:

Laser/radar (distance Sensor)
C2580-44 Control Unit Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC dete ...

C1f4f-82 Bcm Can Circuit 1
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection conditi ...

P059f Active Grille Shutter
Dtc Description DTC Description DTC DETECTION LOGIC Active grille shutter normally stops within zone which is defined by zone (90°±20°). If the active grille shutter stops within zone stuck error is detected, and if the active grille shutter stops at position beyond zon ...