S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: Stall Test

Work Procedure

Work Procedure

INSPECTION

Check the engine oil level. Replenish if necessary. Refer to Inspection.

Check for leak of the CVT fluid. Refer to Inspection.

Drive for about 10 minutes to warm up the Nissan Sentra vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F).

Be sure to apply the parking brake and block the tires.

Start the engine, depress the brake pedal and put the selector lever to the D position.

While depressing the brake pedal, depress the accelerator pedal gradually.

Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.

CAUTION:

Do not depress the accelerator pedal for 5 seconds or more during the test.

Stall speed

: Refer to Stall Speed.

Place the selector lever in the N position.

Cool the CVT fluid.

CAUTION:

Run the engine with the idle speed for at least 1 minute.

Put the selector lever to the R position and perform Step 6 to Step 9 again.

NARROWING-DOWN MALFUNCTIONING PARTS

Selector lever position

Possible cause

D

R

Stall speed

H

O

  • Forward clutch

O

H

  • Reverse brake

L

L

  • Engine

  • Torque converter one way clutch

H

H

  • Line pressure is low.

  • Primary pulley

  • Secondary pulley

  • Steel belt

O: Within the stall speed standard value.

H: Stall speed is higher than the standard value.

L: Stall speed is lower than the standard value.

    Decel G Sensor Calibration
    Description Description TCM stores calibration data (inherent characteristic value) of decel G sensor to provide accurate control. Therefore, it is required to perform calibrati...
    Cvt Position
    Inspection Inspection Place selector lever in “P” position, and place ignition switch ON (engine stop). Make sure that selector lever can be shifted to other than “P” po...

    Other materials:

    C1734-16 Tire Pressure Sensor Rr
    Dtc Description DTC Description Note: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure rep ...

    Ecu Diagnosis Information. Av Control Unit
    Av Control Unit List of Ecu Reference List of ECU Reference ECU Reference AV control unit Values on the Diagnosis Tool ...

    U0101 Can Comm Circuit
    Dtc Description DTC Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Sentra vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control un ...