Nissan Sentra Service Manual: Manual air conditioner

Removal and installation

A/C SWITCH ASSEMBLY Removal and Installation REMOVAL Remove the CVT shift selector finisher (CVT: RE0F11A). Refer to TM-253, "Removal and Installation". Remove the MT shift select ...

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-T ...

Other materials:

Removal and installation
Starter motor Exploded View “S” terminal harness “B” terminal harness Starter motor Cylinder block Removal and Installation NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling. REMOVAL Dis ...

Removal and installation
SIDE OIL SEAL Removal and Installation REMOVAL Remove front drive shafts. Refer to FAX-18, "6M/T : Removal and Installation (LH)". Remove differential side oil seals (1) from clutch housing and transaxle case using a suitable tool. CAUTION: Do not damage transaxle case an ...

Headlamp (lo) circuit
Description The ipdm e/r (intelligent power distribution module engine room) controls the headlamp low relay based on inputs from the bcm over the can communication lines. When the headlamp low relay is energized, power flows through fuses 43 and 44, located in the ipdm e/r. Power then flows ...