Nissan Sentra Service Manual: DTC/Circuit diagnosis
- U1000 CAN Comm circuit
- U1010 Control unit (CAN)
- B0001, B0002 Driver airbag module
- B0010, B0011 Passenger airbag module
- B0020 Side airbag module LH
- B0021 Side curtain air bag module LH
- B0028 Side airbag module RH
- B0029 Side curtain air bag module RH
- B0091 Front side air bag satellite sensor LH
- B0092 Rear side air bag satellite sensor LH
- B0093 FRont door satellite sensor LH
- B0094 Crash zone sensor
- B0096 Front side air bag satellite sensor RH
- B0097 Rear side air bag satellite sensor RH
- B0098 Front door satellite sensor RH
- B1428 Seat belt buckle switch LH
- B1429 Seat belt buckle switch RH
- B1430, B1432 Seat belt pre-tensioner LH
- B1431, B1433 Seat belt pre-tensioner RH
- B142A Ignition voltage
- B142X Collision detection
- B14XX Air bag diagnosis sensor unit
- B00A0 OCS System
- B00D5 Passenger air bag OFF Indicator
Intermittent incident
Inspection procedure
INTERMITTENT TROUBLE
An intermittent incident may have occurred in the past but is not being
detected currently. This DTC will not be
detected on SELF-DIAG [CURRENT], but may ...
U1000 CAN Comm circuit
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and exc ...
Other materials:
Mixture ratio self-learning value
clear
Description
This describes how to erase the mixture ratio self-learning value. For the
actual procedure, follow the instructions
in “Diagnosis Procedure”.
Work Procedure
1.START
With CONSULT
Start engine and warm it up to normal operating temperature.
Select “SELF-LEARNI ...
Engine Oils
Prolonged and repeated contact with used engine oil may cause skin cancer.
Try to avoid direct skin contact
with used oil.
If skin contact is made, wash thoroughly with soap or hand cleaner as soon as
possible.
HEALTH PROTECTION PRECAUTIONS
Avoid prolonged and repeated contact with oils ...
Door switch
Component Function Check
1.Check function
Select DOOR LOCK of BCM using CONSULT
Select door sw-dr, door sw-as in data monitor mode
Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Door switch is OK.
NO ...
