Nissan Sentra Service Manual: Dlc branch line circuit

Nissan Sentra Service Manual / Electrical & power control / Lan system / Can system (type 5) / Dlc branch line circuit

Diagnosis procedure

1.Check connector

Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side).

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector.

2.Check harness for open circuit

Check the resistance between the data link connector terminals.

Is the measurement value within the specification?

Is the measurement value within the specification? Yes (present error)>>check can system type decision again.

Yes (past error)>>error was detected in the data link connector branch line circuit.

No >> repair the data link connector branch line.

A-bag branch line circuit

Diagnosis procedure Warning: Always observe the following items for preventing accidental activation. Before servicing, turn ignition switch off, disconnect battery negative terminal, and w ...

Eps branch line circuit

Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the eps control unit for dam ...

Other materials:

P0461 Fuel level sensor
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0461 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. If DTC P0461 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC-350, "DTC Logic". Driving long distan ...

Pregnant women
NISSAN recommends that pregnant women use seat belts. The seat belt should be worn snug and always position the lap belt as low as possible around the hips, not the waist. Place the shoulder belt over your shoulder and across your chest. Never run the lap/shoulder belt over your abdominal ar ...

Cooling fan
Component Function Check 1.CHECK COOLING FAN FUNCTION With CONSULT Turn ignition switch ON. Perform вЂњFANвЂќ in вЂњACTIVE TESTвЂќ mode of вЂњENGINEвЂќ using CONSULT Check that cooling fan operates at low speed or high speed. Without CONSULT Activate IPDM E/R auto ...