Nissan Sentra Service Manual: Lan system
- Can fundamental
- Can
- Can system (type 1)
- Can system (type 2)
- Can system (type 3)
- Can system (type 4)
- Can system (type 5)
Removal and installation
Bcm (body control module)
Removal and Installation
Note:
Before replacing bcm, perform “read configuration” to save or print
current vehicle specification. Refer
to bcs-116, "conf ...
Can fundamental
...
Other materials:
Fuel pressure
Work Procedure
FUEL PRESSURE RELEASE
1.FUEL PRESSURE RELEASE
With CONSULT
Turn ignition switch ON.
Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using
CONSULT
Start engine.
After engine stalls, crank it two or three times to release ...
Replacement operations
Description
This section is prepared for technicians who have attained a high level of
skill and experience in repairing collision-
damaged vehicles and also use modern service tools and equipment. Persons
unfamiliar with body
repair techniques should not attempt to repair collision-damaged v ...
Squeak and rattle trouble diagnoses
Work Flow
Customer interview
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the diagnostic
worksheet during the interview to document the facts and conditions when the
noise occurs and any
customer's comments; refer to rf-37, "d ...
