Nissan Sentra Service Manual: Battery current sensor
Exploded view
- Battery current sensor
- Current sensor harness connector
Removal and installation
Removal
- Loosen the battery terminal nut and disconnect battery negative terminal. Refer to PG-50, "Exploded View".
- Disconnect the harness connector from current sensor.
- Remove the battery current sensor from the negative terminal.
Installation
Installation is in the reverse order of removal.
Reset electronic systems as necessary. Refer to pg-7, "additional service when removing battery negative terminal : special repair requirement".
Battery terminal with fusible link
Exploded view
Battery terminal with fusible link
Harness connector
Removal and installation
Removal
Loosen the battery terminal nuts and disconnect both battery negative and
positive ...
Service data and specifications (SDS)
Battery
...
Other materials:
Parts Requiring Angle Tightening
Use the Tool for the final tightening of the following engine parts:
Tool number : KV10112100 (BT-8653-A)
Camshaft sprocket (INT) bolt
Cylinder head bolts
Main bearing cap bolts
Connecting rod cap bolts
Crankshaft pulley bolt (No the angle wrench is required as bolt flange
is pr ...
Doors
When the doors are locked using one of the
following methods, the doors cannot be opened
using the inside or outside door handles. The
doors must be unlocked to open the doors.
WARNING
Always have the doors locked while
driving. Along with the use of seat belts,
this provides ...
C1113, C1145, C1146 Yaw rate/side/decel G Sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1113
G SENSOR
When a malfunction is detected in longitunal G sensor
signal.
ABS actuator and electric unit (control unit)
C1145
YAW RATE ...
