Nissan Sentra B18 (2020-2025) Service Manual: Stop Lamp Switch
Component Inspection
-
CHECK STOP LAMP SWITCH
-
-
Ignition switch OFF.
-
Disconnect stop lamp switch connector.
-
Check continuity between stop lamp switch terminals.
Stop lamp switch
Condition
Continuity
Terminals
1
2
Brake pedal
Not depressed
No
Depressed
Yes
-
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace stop lamp switch. Refer to Exploded View.
-
Cvt Shift Selector (detent Switch)
Component Inspection
Component Inspection
CHECK CVT SHIFT SELECTOR (DETENTION
SWITCH)
Ignition switch OFF.
...
Starter Cut Relay
Component Inspection
Component Inspection
CHECK STARTER CUT RELAY
Ignition switch OFF.
Di ...
Other materials:
Maintenance :: Precaution. Precautions. Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precautions. Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precaution for Supplemental Restraint System (SRS) "AIR BAG" an ...
C1712-7b Low Tire Pressure Fr
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure rep ...
DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT
Description
Refer to lan-7, "can communication system : system description".
Dtc logic
Dtc detection logic
Note:
U1000 can be set if a module harness was disconnected and reconnected,
perhaps during a repair. Confirm
that there are actual CAN diagnostic symp ...