Nissan Sentra Service Manual: Removal and installation

Rear disc brake

Brake Burnishing CAUTION: Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft ...

Brake pedal

Exploded View WITHOUT BRAKE PEDAL POSITION SWITCH Snap pin Brake pedal assembly Brake pedal pad Stop lamp switch Clip Clevis pin Apply multi-purpose grease. WITH BRAKE PEDAL POSI ...

Other materials:

Daytime light system inoperative
Description The daytime light system is inoperative even though the combination switch (lighting and turn signal switch) and parking brake switch are in the normal setting, also whenever engine is operating. Diagnosis procedure 1.Check daytime light operation Perform bcm(headlamp) daytim ...

Using the system
Initialization When the ignition switch is in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the system is ready to accept voice commands. If the button is pressed before the initialization completes, the system will announce: “Voice ...

On Board Diagnostic (OBD) System of Engine and CVT
The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration. CAUTION: Be sure to turn the ignition switch OFF and disconnect the negative battery cable before any repair or inspection ...