Nissan Sentra Service Manual: Removal and installation

Front drive shaft

Inspection Check the following items, and replace the part if necessary. Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft assembly whe ...

Front wheel hub

Exploded View Steering knuckle Splash guard Wheel stud Wheel hub and bearing Disc brake rotor Wheel hub lock nut Nut retainer Cotter pin Removal and Installation Remove t ...

Other materials:

P0524 Engine oil pressure
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0524 ENGINE OIL PRESSURE (Engine oil pressure too low) An EOP sensor signal voltage applied to ECM remains lower than the specified ...

Rear disc brake
BRAKE PAD BRAKE PAD : Inspection PAD WEAR Check pad thickness from an inspection hole on caliper body. Check using a scale if necessary. Wear limit thickness : Refer to BR-55, "Rear Disc Brake". DISC ROTOR DISC ROTOR : Inspection APPERANCE Check surface of disc rotor for unev ...

Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On DIAGNOSTIC PROCEDURE 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO > ...