Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
Remove rear suspension member. Refer to Removal and Installation.
Remove the front and rear lower link nut and bolt from the rear suspension member using power tool.
Remove front and rear lower link nut and bolt from the rear knuckle using power tool.
Remove the front link and rear lower link as an assembly.
Remove lower rear suspension link bolts.
Separate front lower link and rear lower link.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not reuse rear lower nuts.
-
Make sure that the upper seat is attached as shown.
CAUTION:
-
Keep the upper seat (1) in place during coil spring installation. The protrusion (A) on the Nissan Sentra vehicle fits inside upper seat (2)
-
-
Match up the lower seat indentions and the rear lower link grooves.
-
When installing the coil spring, position the coil spring using marking.
CAUTION:
Position the coil spring with the 1 marking 1.75 turns from the top.
-
Install the coil spring by aligning the lower end of the coil spring (1) to the bump on the lower spring seat (2).
(A)
: Maximum gap 5 mm (0.20 in)
-
Perform the final tightening of the parts under unladen conditions with the tires on the ground.
-
Check the wheel alignment. Refer to Wheel Alignment (Unladen*1).
-
Adjust the neutral position of the steering angle sensor. Refer to Description.
Exploded View
Exploded View
With Drum Brake
1.
Rear suspension member
...
Inspection
Inspection
INSPECTION AFTER REMOVAL
Check the
upper rubber seat, the lower rubber seat, and the coil spring for
deformation, cracks, and damage.
Replace the
parts if necessary.
...
Other materials:
Door Check Link
Removal and Installation
Removal and Installation
REMOVAL
Remove rear
door finisher. Refer to Removal and Installation.
Partially
remove vapor barrier (front).
Remove door
check link bolt from (body side).
Remove door
check link bolts from (door side).
Remove d ...
ECO mode switch
ECO mode switch
The ECO mode helps to enhance the fuel
economy by controlling the throttle sensitivity and
transmission points (CVT if so equipped).
To turn on the ECO mode, push the ECO mode
switch. The ECO mode indicator light (on the
speedometer) will remain lit while the mode is
act ...
Tire labeling
Example
Federal law requires tire manufacturers to place standardized and clearly readable
information on the sidewall of all tires installed on vehicles such as the Nissan
Sentra.
This information identifies and explains the fundamental characteristics of the
tire and also includes the ...
