Nissan Sentra Service Manual: Hvac branch line circuit
Diagnosis procedure
1.Check connector
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal
- Check the terminals and connectors of the a/c auto amp. For damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? Yes >> go to 2.
No >> repair the terminal and connector.
2.Check harness for open circuit
- Disconnect the connector of a/c auto amp.
- Check the resistance between the a/c auto amp. Harness connector terminals.
Is the measurement value within the specification? Yes >> go to 3.
No >> repair the a/c auto amp. Branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the a/c auto amp. Refer to hac-83, "a/c auto amp. : Diagnosis procedure".
Is the inspection result normal? Yes (present error)>>replace the a/c auto amp. Refer to hac-105, "removal and installation".
Yes (past error)>>error was detected in the a/c auto amp. Branch line.
No >> repair the power supply and the ground circuit.
Strg branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor fo ...
BCM branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the bcm for damage, bend and ...
Other materials:
Air bags, seat belts and child restraints
Top tether anchor
Rear seat belts
Roof-mounted curtain side-impact
supplemental air bag
Head restraints/headrests
Front seat belts
Supplemental front-impact air bags
Front seats
Occupant classification sensor
Seat belt with pretensioner
Front seat-mounted side-impact
sup ...
SRS Air bag warning lamp does not turn ON
Diagnosis Procedure
1.CHECK COMBINATION METER POWER SUPPLY AND GROUND CIRCUIT
Check combination meter unit power supply and ground circuit. Refer to
MWI-52, "COMBINATION METER :
Diagnosis Procedure".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or r ...
C1113, C1145, C1146 Yaw rate/side/decel G Sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1113
G SENSOR
When a malfunction is detected in longitunal G sensor
signal.
ABS actuator and electric unit (control unit)
C1145
YAW RATE ...
