Nissan Sentra B18 (2020-2025) Service Manual: Front Pillar Finisher
Removal and Installation
REMOVAL
Partially remove the front body side welt along the front pillar finisher.
Using a
suitable tool, release clips and pawls of front pillar finisher
(1).
: Clip
:
Pawl
Using a
suitable tool, cut each tether clip to release front pillar
finisher.
CAUTION:
Do not reuse front pillar finisher tether clip.
Remove front pillar finisher tether clips from front pillar finisher and body panel.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Always replace tether clips with new ones after every removal.
-
When installing, check that tether clips are accurately aligned with the holes on body panel, then press in.
Exploded View
Exploded View
1.
Rear body side welt
2.
...
Kicking Plate
Removal and Installation
Removal and Installation
FRONT
Removal
Using a
suitable tool, release pawls.
:
Pawl
Remove
front kicking plate (1).
Installation
Instal ...
Other materials:
Removal and Installation
Removal and
Installation
REMOVAL
Remove the emblem from the panel
heating with a heat gun.
CAUTION:
Do not damage the painted surface of the panel
when removing the emblem.
INSTALLATION
Note:
Do not reuse the emblem.
Ensure Niss ...
Exploded View
Exploded View
60:40 SPLIT SEATBACK
1.
Seatback striker
2.
Rear seatback insulator
(RH)
...
Removal and Installation
Removal and Installation
CAUTION:
Be careful not to scratch instrument panel and
other parts.
Before servicing, turn ignition switch OFF,
disconnect both battery terminals and wait at least three
minutes.
...
