Nissan Sentra Service Manual: DTC/Circuit diagnosis

ID registration procedure

Description This procedure must be performed after replacing wheels, transmitters or the BCM, or rotating wheels. Work Procedure TPMS ID registration can be performed using one of the following ...

C1704, C1705, C1706, C1707 Low tire pressure

DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS ...

Other materials:

Body sealing
Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffected parts to come into conta ...

Condenser
Removal and installation Removal Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FINISHER : Removal and Installation". Disconnect the harness connectors (1), remove the condenser bolt (A) and the condenser (2). : Front Installation Installation is in th ...

G Sensor
Exploded View G sensor Bracket Vehicle front NВ·m (kg-m, ft-lb) NВ·m (kg-m, in-lb) Removal and Installation WARNING: Do not leave any objects (screwdrivers, tools, etc.) on the seat during seat repair. It can lead to personal injury if the side air bag module should acc ...