Nissan Sentra Service Manual: Low tire pressure warning lamp
Component Function Check
1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.
Is the inspection result normal? YES >> Inspection End.
NO >> Perform trouble diagnosis. Refer to WT-33, "Diagnosis Procedure".
Diagnosis Procedure
1.PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
- Turn the ignition switch ON.
- Perform “SELF DIAGNOSTIC RESULT”.
Are any DTCs detected? YES >> Refer to BCS-49, "DTC Index" (with Intelligent Key system) or BCS-109, "DTC Index" (without Intelligent Key system).
NO >> GO TO 3.
2.CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL
With CONSULT
- Turn the ignition switch ON.
- On “DATA MONITOR” select “WARNING LAMP.”
- Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.
Is the inspection result normal? YES >> Check the combination meter. Refer to MWI-17, "CONSULT Function (METER/M&A)".
NO >> Replace the BCM. Refer to BCS-73, "Removal and Installation" (with Intelligent Key system) or BCS-126, "Removal and Installation" (without Intelligent Key system).
C1729 Vehicle speed signal
DTC Logic
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS ...
Power supply and ground circuit
WITH INTELLIGENT KEY SYSTEM
WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-51, "Wiring Diagram".
1.Check fuses and fusible link
Chec ...
Other materials:
During a call
While a call is active, press the
button to
access additional options. Speak one of the following
commands:
“(numbers)” – Speak numbers and then say
“Send” or say “Correction” to change the
numbers entered.
“Mute On” or “Mute Off” – Speak the command
to mute ...
Hvac branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal
Check the terminals and connectors of the a/c auto amp. For damage, bend
and loose connection (unit
side and connector side).
Is the inspection result normal?
...
System initialization
Description
If any of the following operations are performed, the initialization is
necessary for normal operation of power
window system.
Disconnection and connection of battery cable from negative terminal.
When power window main switch replaced.
Electric power supply to power window m ...
