Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Owner's Manual: Drive belt

Nissan Sentra drive belt routing diagram

  1. Automatic tensioner pulley
  2. Generator pulley
  3. Water pump pulley
  4. Air conditioner compressor pulley
  5. Crankshaft pulley

WARNING

Ensure that the ignition switch is in the OFF or LOCK position before servicing the drive belt. The engine may rotate unexpectedly and cause serious injury.

1. Visually inspect the drive belt for signs of abnormal wear, cracking, cuts, glazing, or fraying. If any damage is found, the belt should be replaced or adjusted.

It is recommended that drive belt inspection and replacement be performed by a NISSAN dealer.

2. Have the drive belt inspected regularly as part of scheduled maintenance to ensure proper operation of engine accessories.

    Variable voltage control system
    CAUTION Do not ground electrical accessories directly to the battery terminal. Doing so bypasses the variable voltage control system and may prevent the battery from charging pr...
    Spark plugs
    Replacing spark plugs WARNING Make sure the engine and ignition switch are OFF and the parking brake is securely applied before replacing spark plugs. CAUTION Always use the cor...

    Other materials:

    P0102 Maf Sensor
    Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

    U0073-00 Control Module Comm Bus a Off
    Dtc Description DTC Description DESCRIPTION CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Sentra vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan ...

    Av Branch Line Circuit
    Diagnosis Procedure Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and ...