Nissan Sentra B18 (2020-2025) Owner's Manual: Variable voltage control system

CAUTION
- Do not ground electrical accessories directly to the battery terminal. Doing so bypasses the variable voltage control system and may prevent the battery from charging properly.
- Operate electrical accessories with the engine running whenever possible to avoid unnecessary battery discharge.
Your Nissan Sentra is equipped with a variable voltage control system that monitors battery discharge and regulates the voltage generated by the vehicle’s generator accordingly.
The current sensor A is located near the battery along the negative battery cable. When installing additional electrical accessories, always ground them to a proper body ground such as the vehicle frame or engine block.
Other materials:
Line Pressure Solenoid Valve Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK HARNESS CONNECTOR
Ignition switch OFF.
Check the mating condition of TCM
harness connector and CVT unit harness
connector.
Is the inspect ...
Pre-Inspection for Diagnosis
Work Procedure
Work Procedure
CHECK CAMERA LENS AND WINDSHIELD
Are camera lens and windshield contaminated with
foreign materials?
YES (When the camera lens is
contaminated with foreign materials.) >>
Replace front camera unit (Refer to R ...
Trip Reset Switch Signal Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK TRIP RESET SWITCH SIGNAL
Ignition switch ON.
Check voltage between the following terminals of
the trip reset switch harness con ...