Nissan Sentra B18 (2020-2025) Service Manual: Pre-Inspection for Diagnosis
Work Procedure
-
CHECK CAMERA LENS AND WINDSHIELD
Are camera lens and windshield contaminated with foreign materials?
YES (When the camera lens is contaminated with foreign materials.) >>Replace front camera unit (Refer to Removal and Installation.) and GO TO 2.
YES (When the windshield is contaminated with foreign materials.) >>Clean windshield.
NO >>GO TO 2.
-
CHECK FRONT CAMERA UNIT INSTALLATION CONDITION
Check front camera unit installation condition (installation position, properly tightened, a bent bracket).
Is it properly installed?
YES >>GO TO 3.
NO >>Install front camera unit properly, and perform camera aiming.
-
CHECK Nissan Sentra Vehicle HEIGHT
Check vehicle height. Refer to Wheelarch Height (Unladen).
Is vehicle height appropriate?
YES >>INSPECTION END
NO >>Repair Nissan Sentra vehicle to appropriate height.
Additional Service When Replacing Front Camera Unit
Work Procedure
Work Procedure
Always perform the front camera unit configuration after
replacing the front camera unit.
Always perform the camera aiming after ...
Camera Aiming Adjustment
Work Procedure
Work Procedure
Always adjust the camera aiming after removing and
installing or replacing the front camera unit.
Always adjust the camera aiming ...
Other materials:
Symptom diagnosis
Power door lock system symptoms
Symptom table
Door lock/unlock function malfunction
Note:
Before performing the diagnosis in the following table, check “WORK
FLOW”. Refer to DLK-245, "Work
Flow".
Check that vehicle is under the condition shown in “conditions of ...
If your vehicle overheats
If your Nissan Sentra begins to overheat, which may be indicated by an extremely
high temperature gauge reading, a noticeable loss of engine power, unusual smells,
steam, or abnormal engine noise, take the following steps immediately to protect
the engine and ensure personal safety.
WARNING
...
Push-button ignition switch positions
LOCK (Normal parking position):
The ignition switch can only be locked in this
position.
The ignition switch will be unlocked when it is
pushed to the ACC position while carrying the
Intelligent Key or with the Intelligent Key inserted
in the port.
The ignition switch will lock when any d ...
