Nissan Sentra B18 (2020-2025) Service Manual: Additional Service When Replacing Front Camera Unit

Nissan Sentra B18 (2020-2025) Service Manual / Cruise Control & Driver Assistance / Driver Assistance System :: Driver Assistance System / Basic Inspection / Additional Service When Replacing Front Camera Unit

Work Procedure

Work Procedure

Always perform the front camera unit configuration after replacing the front camera unit.
Always perform the camera aiming after removing and installing or replacing the front camera unit.

CAUTION:

The system does not operate normally unless the front camera unit configuration and the camera aiming adjustment are performed. Always perform them.

FRONT CAMERA UNIT CONFIGURATION

Perform the front camera unit configuration with CONSULT. Refer to Work Procedure.

>>
GO TO 2.
CAMERA AIMING ADJUSTMENT

Perform the camera aiming adjustment with CONSULT. Refer to Work Procedure.

>>
GO TO 3.
PERFORM SELF-DIAGNOSIS

Perform the self-diagnosis of front camera unit with CONSULT. Check if any DTC is detected.

Is any DTC detected?
YES >>
Perform the trouble diagnosis for the detected DTC. Refer to DTC Index.
NO >>
GO TO 4.
LDW/AEB SYSTEM ACTION TEST
1. Perform the LDW/AEB system action test.
  - LDW: Refer to Work Procedure.
  - AEB: Refer to Work Procedure.
2. Check that the LDW/AEB system operates normally.
>>
WORK END

Configuration (distance Sensor)

Work Procedure Work Procedure Since vehicle specifications are not included in the distance sensor after replacement, it is required to write Nissan Sentra vehicle spe ...

Pre-Inspection for Diagnosis

Work Procedure Work Procedure CHECK CAMERA LENS AND WINDSHIELD Are camera lens and windshield contaminated with foreign materials? YES (When the camera lens ...

Other materials:

Outside mirrors
The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position. Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2 . WARNING Objects viewed in the outside mi ...

P2004 Intake Manifold Runner Control
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

P0720 Output speed sensor
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0720 OUTPUT SPEED SENSOR (Output Speed Sensor Circuit) The output speed sensor value is less than 150 rpm continuously for 5 seconds ...