Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Display Audio with Bose with 8" Color Display / Dtc/circuit Diagnosis / U1231 Amplifier Temperature

Nissan Sentra B18 (2020-2025) Service Manual: U1231 Amplifier Temperature

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)		DTC detection condition
U1231–98	AMP TEMP (Amp temperature)	—	Diagnosis condition	When ignition switch is ON.
			Signal (terminal)	—
			Threshold	—
			Diagnosis delay time	—

POSSIBLE CAUSE

Bose speaker amp. temperature is high
Bose speaker amp.

FAIL-SAFE

Bose system does not function

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Ignition switch OFF and wait at least 30 seconds.
  3. Ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “AUDIO AMP.”.
  5. Check DTC.
Is DTC U1231–98 detected?
YES>>
Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK AROUND BOSE SPEAKER AMP.
1. Check whether there is any factor which causes a temperature rise near Bose speaker amp.
Was there any factor?
YES >>
Remove a factor.
NO >>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Perform confirmation procedure again. Refer to DTC Diagnosis Procedure.
Is DTC U1231–98 detected again?
YES >>
Replace Bose speaker amp. Refer to Removal and Installation.
NO >>
Inspection End.

 U1000 Can Comm Circuit

Av Control Unit Dtc Description DTC Description DESCRIPTION CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Sentra veh...

 U1300 Av Communication Circuit

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1300–01 AV communication circuit (AV comm...

Other materials:

Select Learning
Work Procedure Work Procedure Note: Always perform Clutch Point Learning before Select Learning. Perform Select Learning with CVT fluid temperature below 50°C (122°F) and again with fluid temperature above 50°C (122°F). ...

Symptom Diagnosis
The Fuel Gauge Indicator Does Not Operate Description Description Fuel gauge will not indicate from a certain position. Diagnosis Procedure Diagnosis Procedure PERFORM COMBINATION METER SELF-DIAGNOSIS MODE Perform the self-diagnosis mode ...

Preparation. Preparation
Preparation Special Service Tool Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name ...