Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Owner's Manual: Battery

Nissan Sentra battery location and specifications

NOTE:

Care should be taken to avoid situations that may cause battery discharge and potential no-start conditions, including the following:

1. Installation or extended use of electronic accessories that draw power while the engine is not running, such as phone chargers, GPS units, dash cameras, DVD players, or other aftermarket devices.

2. The vehicle is not driven regularly or is driven only for short distances, which may prevent the battery from fully recharging.

In these situations, the battery may require periodic charging to maintain optimal battery health and performance.

WARNING

Nissan Sentra battery safety and warning labels

NOTE:

Do not attempt to open the top of the battery.

This battery is not equipped with removable vent caps and is designed to operate as a sealed unit.

Jump starting

If jump starting becomes necessary, refer to the "Jump starting" section of this manual. If the engine of your Nissan Sentra does not start after jump starting, the battery may need to be replaced. It is recommended that you visit a NISSAN dealer for this service.

Windshield-washer fluid
Windshield-washer fluid reservoir Periodically fill the windshield-washer fluid reservoir. Add washer fluid whenever the "Low Washer Fluid" warning message (if so equipped) appears i ...

Variable voltage control system
CAUTION Do not ground electrical accessories directly to the battery terminal. Doing so bypasses the variable voltage control system and may prevent the battery from charging properly. ...

Other materials:

Icc Steering Switch (other Than Main Switch) Does Not Function
Diagnosis Procedure Diagnosis Procedure ICC MAIN switch can be turned ON/OFF, but the operation of RES+ switch, CANCEL switch, and DISTANCE switch cannot be performed during ICC system operation. Note: Resume is not accepted when the following condition is met. Wh ...

Ecu diagnosis information
Bcm Reference value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTC ...

U2148-83 Can Communication
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition ...

© 2014-2026 Copyright www.nisentra.com