Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C1604-96 Torque Sensor / Confirmation Procedure

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Start the engine.
    
    CAUTION:
    
    Never drive the Nissan Sentra vehicle.
  2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1604-96” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC No. CONSULT screen terms (Trouble diagnosis content) ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure PERFORM SELF DIAGNOSIS RESULT CONSULT Ignition switch ON. ...

Other materials:

Power supply and ground circuit
BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS-51, "Wiring Diagram". 1.Check fuses and fusible link Check that the following fuses and fusible link ...

Precautions on child restraints
WARNING Failure to carefully follow all warnings and instructions regarding the proper use and installation of child restraints can result in serious injury or death to a child or other passengers during a sudden stop or collision in the Nissan Sentra: The child restraint must ...

Hazard switch
Component function check 1.Check hazard switch signal by consult Consult data monitor Turn ignition switch ON. Select hazard sw of bcm (flasher) data monitor item. While operating the hazard switch, check the monitor status. Is the inspection result normal? Yes >> hazard swi ...