Nissan Sentra B18 (2020-2025) Service Manual: C1604-96 Torque Sensor
Dtc Description
DTC Description
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|---|---|---|---|
|
C1604–96 |
TORQUE SENSOR (Torque sensor) |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
Torque sensor signal |
||
|
Threshold |
When a malfunction is detected in torque sensor. |
||
|
Diagnosis delay time |
1 second or less |
||
POSSIBLE CAUSE
-
Harness or connector
-
Torque sensor
-
EPS control unit
FAIL-SAFE
Manual steering state
Confirmation Procedure
Confirmation Procedure
-
PRECONDITIONING
-
If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
-
-
DTC REPRODUCTION PROCEDURE
-
CONSULT-
Start the engine.
CAUTION:
Never drive the Nissan Sentra vehicle.
-
Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
-
Is DTC “C1604-96” detected?
YES >>Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
PERFORM SELF DIAGNOSIS RESULT
-
CONSULT-
Ignition switch ON.
-
Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
-
Ignition switch OFF and wait for at least 10 seconds.
-
Start the engine.
CAUTION:
Never drive the Nissan Sentra vehicle.
-
Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
-
Is DTC “C1604-96” detected?
YES>>Torque sensor is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.
NO>>Check pin terminal and connection of each harness connector for malfunctioning conditions.
-
Other materials:
B20bd-96 Battery Current Sensor
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen items
(Trouble diagnosis content)
DTC Detection Condition
...
Door Lock and Unlock Switch
Driver Side
Component Function Check
Component Function
Check
CHECK FUNCTION
CONSULT
Ignition switch ON.
Select ″CDL LOCK SW″, ″CDL UNLOCK SW″ in ″Data
...
P059f Active Grille Shutter
Dtc Description
DTC Description
DTC DETECTION LOGIC
Active grille shutter normally stops within zone which
is defined by zone (90°±20°).
If the active grille shutter stops within zone stuck
error is detected, and if the active grille shutter stops at position beyond
zon ...