WARNING
CAUTION
NISSAN Intelligent Key

The Nissan Sentra Intelligent Key uses a lithium coin battery. Replace the battery using the procedure below to ensure reliable remote locking, unlocking, and vehicle starting functions.
1. Remove the mechanical key from the Nissan Sentra Intelligent Key.
2. Insert a small flathead screwdriver A into the slit B at the corner of the key case and gently twist to separate the upper and lower halves. Place a soft cloth over the screwdriver to prevent damage to the casing.

3. Replace the battery with a new one.
Recommended battery type: CR2032 or equivalent.
4. Close the key case securely, ensuring it snaps together properly as illustrated by points C and D.
5. Press the Intelligent Key buttons to confirm proper operation.
If assistance is required during battery replacement, it is recommended that you visit a NISSAN dealer for professional service.
FCC Notice:
For USA:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note:
Changes or modifications not expressly approved by the party responsible for compliance may void the user's authority to operate this equipment.
For Canada:
This device contains licence-exempt transmitter(s) and receiver(s) that comply with Innovation, Science and Economic Development Canada licence-exempt RSS standards. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Fuses
LightsPrecautions
Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as
“AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along wit ...
Rear Seat Belt Retractor
Removal and Installation
Removal and Installation
Rear Seat Belt Retractor (LH/RH)
REMOVAL
Warning:
Before servicing the SRS, place the ignition
switch in the OFF position, disconnect both battery terminals then
wait at least three minutes.
...
Rear seat
Exploded View
Rear seatback assembly (RH)
Seatback striker
Seatback latch release knob
Seatback latch assembly
Seatback silencer (RH)
Rear seatback frame (RH)
Seatback latch release knob finisher
Rear seat bolster trim (RH)
Rear seat bolster pad (RH)
Rear seat bolster (RH)
...