Nissan Sentra B18 (2020-2025) Service Manual: Stop Lamp Switch
Component Inspection
-
CHECK STOP LAMP SWITCH 1
-
-
Ignition switch OFF.
-
Disconnect stop lamp switch connector.
-
Check continuity between stop lamp switch terminals.
Stop lamp switch
Condition
Continuity
Terminals
1
2
Brake pedal
Depressed
Yes
Fully released
No
-
Is the inspection result normal?
YES >>Inspection End.
NO >>GO TO 2.
-
-
CHECK STOP LAMP SWITCH 2
-
-
Adjust stop lamp switch installation. Refer to Adjustment.
-
Check continuity between stop lamp switch terminals.
Stop lamp switch
Condition
Continuity
Terminals
1
2
Brake pedal
Depressed
Yes
Fully released
No
-
Is the inspection result normal?
YES >>Inspection End.
NO >>Replace stop lamp switch. Refer to Removal and Installation.
-
Stop Lamp
Component Inspection
Component Inspection
CHECK STOP LAMP 1
Ignition switch OFF.
Disconne ...
Hazard Switch
Component Inspection
Component Inspection
CHECK HAZARD SWITCH
Ignition switch OFF.
Discon ...
Other materials:
Adjustment
Adjustment
BALANCING WHEELS (ADHESIVE WEIGHT TYPE)
Preparation Before Adjustment
Remove inner and outer balance weights from the
wheel. Using releasing agent, remove double-faced adhesive tape
from the wheel.
CAUTION:
Be careful not to scratch the wheel and tir ...
Dtc Diagnosis Procedure
DTC Diagnosis
Procedure
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported ...
Rear window defogger power supply and ground circuit
Description
Heats the heating wire with the power supply from the rear window defogger
relay to prevent the rear window
from fogging up.
Component function check
1. Check rear window defogger
Check that the heating wire of rear window defogger is heated when turning
the rear window defogge ...
