Nissan Sentra B18 (2020-2025) Service Manual: B24b4-02 A/c Control
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|---|---|---|---|---|
|
B24B4-02 |
A/C CONTROL (Air conditioning control) |
[GENERAL SIGNAL FAILURE] |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
– |
|||
|
Threshold |
– |
|||
|
Diagnosis delay time |
30 seconds or more |
|||
POSSIBLE CAUSE
A/C auto amp. (Internal circuit malfunction)
FAIL-SAFE
—
Confirmation Procedure
Confirmation Procedure
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULT-
Ignition switch ON.
-
Select “Self Diagnostic Result� mode of “HVAC�.
-
Is DTC detected?
YES >>Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULT-
Ignition switch ON.
-
Select “Self Diagnostic Result� mode of “HVAC�.
-
Select “ERASE�.
-
Ignition switch OFF.
-
Ignition switch ON.
-
Perform “DTC CONFIRMATION PROCEDURE�. Refer to Confirmation Procedure.
-
Is DTC detected again?
YES >>Replace A/C auto amp. Refer to Removal and Installation.
NO >>Inspection End.
-
Other materials:
Rear window and outside mirror defroster switch
To defrost the rear window glass and the outside mirrors (if so equipped), start
the engine and press the rear window defroster switch. The indicator light on the
switch will illuminate while the system is active. Press the switch again to turn
the defroster off.
The rear window defroster ...
Warning/Indicator light
Warning/Indicator light (red)
or
Brake warning light
Charge warning light
Engine oil pressure warning light
Malfunction Indicator Light (MIL) (if so equipped)
Master warning light
Seat belt warning light and chime
Supplemental air bag warning light
Warn ...
Rear Suspension. Periodic Maintenance
Rear Suspension Assembly. Inspection
Inspection
Inspection
COMPONENT PART
Check the
mounting conditions (looseness, backlash) of each
component.
Verify
component conditions (wear, damage) are normal.
Oil Leakage Inspection
If oil (A) does not extend beyond the ...