Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: B2205-29 Vehicle Speed

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detected condition

B2205-29

SPEED METER

(Speed meter)

Diagnosis condition

When ignition switch is ON.

Signal (terminal)

Nissan Sentra Vehicle speed display signal

Threshold

An abnormal Nissan Sentra vehicle speed signal is input from ECM

Diagnosis delay time

2 seconds or more

POSSIBLE CAUSE

FAIL-SAFE

Reset to zero of the speedometer by suspending communication.

Confirmation Procedure

Confirmation Procedure
  1. PERFORM DTC CONFIRMATION PROCEDURE

    1. CONSULT

      1. Ignition switch ON.

      2. Select “Self Diagnostic Result” mode of “METER/M&A”.

    Is DTC B2205-29 detected?

    YES >>

    Refer to DTC Diagnosis Procedure.

    NO >>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO >>

    Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure
  1. PERFORM SELF DIAGNOSTIC RESULT OF ECM

    1. CONSULT

      Select “Self Diagnostic Result” mode of “ENGINE”.

    Is DTC detected?

    YES>>

    Perform diagnosis procedure on the detected DTC. Refer to DTC Index.

    NO>>

    GO TO 2.

  2. PERFORM SELF DIAGNOSTIC RESULT OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

    1. CONSULT

      Select “Self Diagnostic Result” mode of “ABS”.

    Is DTC detected?

    YES >>

    Perform diagnosis procedure on the detected DTC. Refer to DTC Index.

    NO >>

    Inspection End.

Other materials:

Front seat belt
Exploded View D-ring anchor Seat belt height adjuster cover Seat belt buckle Seat belt retractor Seat belt height adjuster Lap belt pre-tensioner harness connector Shoulder belt pre-tensioner harness connector Front NOTE: LH side shown; RH side similar. Removal an ...

B1429 Seat belt buckle switch RH
Description DTC B1429 SEAT BELT BUCKLE SWITCH RH The air bag diagnosis sensor unit monitors the seat belt buckle switch RH status. If the control unit detects an open or short condition in the circuit, it will set the DTC. PART LOCATION Refer to SRC-5, "Component Parts Location". D ...

Application Notice
Information Information Service information Design of combination meter TYPE A TYPE B ...

© 2014-2026 Copyright www.nisentra.com