Nissan Sentra B18 (2020-2025) Service Manual: B20c7-11 A/c Clutch

Nissan Sentra B18 (2020-2025) Service Manual / Ventilation, Heater & Air Conditioner / Heater & Air Conditioning Control System :: Automatic Air Conditioner / Dtc/circuit Diagnosis / B20c7-11 A/c Clutch

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)		DTC detection condition
B20C7–11	A/C clutch (A/C clutch)	[CIRCUIT SHORT TO GROUND]	Diagnosis condition	When A/C switch is ON
			Signal (Terminal)	Magnetic clutch ON signal
			Threshold	Magnetic clutch ON signal circuit has a shorted to ground
			Diagnosis delay time	1 second or more

POSSIBLE CAUSE

Harness or connectors (magnetic clutch ON signal circuit is shorted to ground)
IPDM E/R

FAIL-SAFE

Inhibit A/C compressor (magnetic clutch) operation

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Start the engine.
  2. Turn A/C switch ON.
  3. Select “Self Diagnostic Result” mode of “IPDM E/R”.
Is DTC detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK MAGNETIC CLUTCH ON SIGNAL CIRCUIT FOR SHORT

Ignition switch OFF.
Disconnect IPDM E/R connector and A/C compressor connector.

Check continuity between IPDM E/R harness connector and the ground.

IPDM E/R		—	Continuity
Connector	Terminal	—	Continuity
F96	65	Ground	No

Is the inspection result normal?

YES >>

Replace IPDM E/R. Refer to Removal and Installation.

NO >>

Repair harness or connector.

B20c7-15 A/c Clutch

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms ...

Other materials:

Diagnosis Procedure
Diagnosis Procedure CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE Check Intelligent Key system symptom table. Refer to Diagnosis Procedure. >> GO TO 2. CHECK INTELLIGENT KEY LOW BA ...

Dtc/circuit diagnosis
U1000 can comm circuit Description Refer to lan-7, "can communication system : system description". DTC Logic Dtc detection logic Note: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual can diagnostic sym ...

Dtc/circuit diagnosis
Sport mode switch Component function check 1. Check sport mode switch operation Turn ignition switch on. Check SPORT mode indicator lamp turns ON/OFF on combination meter when turn SPORT mode switch ON/OFF. Is the inspection result normal? Yes >> go to 2. No >> procee ...