Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
Combination Meter
Exploded View
|
1. |
Front cover |
2. |
Combination meter |
|
Pawl |
Removal and Installation
REMOVAL
CAUTION:
Be sure to perform the "ADDITIONAL SERVICE WHEN REPLACING COMBINATION METER". Refer to Work Procedure.
Note:
Do not swap combination meter modules between Nissan Sentra vehicles for any reason.
Remove cluster lid A. Refer to Removal and Installation.
Remove the
screws (A) from the combination meter (1).
Disconnect harness connector from the combination meter (1) and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Be sure to perform the "ADDITIONAL SERVICE WHEN REPLACING COMBINATION METER". Refer to Work Procedure.
Note:
Do not swap combination meter modules between Nissan Sentra vehicles for any reason.
Steering Switches
Removal and Installation
For removal and installation of the steering switch, refer to Removal and installation (DISPLAY AUDIO WITH 7" COLOR DISPLAY), Removal and installation (DISPLAY AUDIO WITHOUT BOSE WITH 8" COLOR DISPLAY), or Removal and installation (DISPLAY AUDIO WITH BOSE WITH 8" COLOR DISPLAY).
Illumination Control Switch
Removal and Installation
For removal and installation of the illumination control switch, refer to Removal and Installation.
Trip Reset Switch
Exploded View
|
1. |
Trunk lid opener switch |
2. |
ECO mode switch |
3. |
Illumination control switch |
|
4. |
Trip reset switch |
5. |
Instrument lower panel LH |
|
Pawl |
Removal and Installation
REMOVAL
Remove the instrument lower panel LH. Refer to Removal and Installation.
Release
pawls using suitable tool and remove the trip reset switch from
switch panel. 
|
|
: Pawl |
INSTALLATION
Installation is in the reverse order of removal.
Other materials:
Turn Signal Lamp
Component Inspection
Component Inspection
CHECK TURN SIGNAL LAMP
Ignition switch OFF.
Disconnect front combination lamp connector, rear
combination lamp (body side) connecto ...
Cooling fan
Component
Fan shroud and motor assembly
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns
could occur from high-pressure
engine coolant escaping from the radiator. Wrap a thick cloth around the cap.
Slowly push down and
turn it a quarter turn to allow b ...
System description
Component parts
Component parts location
Instrument lower finisher
Component description
Eco mode switch
The ECO mode switch is installed to the instrument lower finisher.
When the eco mode indicator lamp on the combination meter is
off and the eco mode switch is pressed, t ...