Nissan Sentra B18 (2020-2025) Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Security Control System :: Intelligent Key System / Dtc/circuit Diagnosis / B2033-4a Dongle Ng

Nissan Sentra B18 (2020-2025) Service Manual: B2033-4a Dongle Ng

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen items (Trouble diagnosis content)	DTC detection condition
B2033–4A	DONGLE NG (Dongle not good)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	CAN communication signal
		Threshold	The ID verification results NG
		Diagnosis delay time	1 second or more

POSSIBLE CAUSE

Harness or connector

(The CAN communication line is open or shorted)
Intelligent Key unit
EPS control unit

FAIL-SAFE

—

Dtc Confirmation Procedure

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “HANDS FREE MODULE”.
Is the DTC detected?
YES>>
Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirm after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM INITIALIZATION
1. CONSULT
  1. Perform initialization of Intelligent Key unit and registration of all Intelligent Keys.
    
    For initialization and registration procedures, refer to CONSULT immobilizer mode and follow the on-screen instructions.
  2. Start the engine.
Dose the engine start?
YES >>
Inspection End.
NO >>
GO TO 2.
REPLACE INTELLIGENT KEY UNIT
1. Replace Intelligent Key unit. Refer to Removal and Installation.
Is the DTC detected?
YES >>
GO TO 3.
NO >>
Inspection End.
REPLACE EPS CONTROL UNIT
1. Replace EPS control unit. Refer to Removal and Installation.
>>
Inspection End.

 P161e Immobilizer

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition P161E IMMOBILIZER (Immobilizer) Diagnosis co...

 B2070-68 Key Registration

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2070–68 Key registration (Key registratio...

Other materials:

Spark plugs
Replacing spark plugs WARNING Make sure the engine and ignition switch are OFF and the parking brake is securely applied before replacing spark plugs. CAUTION Always use the correct spark plug socket when removing spark plugs. Using an incorrect socket may damage the spark plugs or cylin ...

Description
Component Parts (8ch Can Gateway) Component Parts Location Component Parts Location Behind the instrument panel (view with instrument panel assemble removed) ...

Removal and Installation. Push-Button Ignition Switch
Push-Button Ignition Switch Removal and Installation Removal and Installation REMOVAL Remove shift selector finisher using the following steps: Remove the CVT shift selector knob. Refer to Removal & Installation. Using a suitable tool, release cli ...