Nissan Sentra B18 (2020-2025) Service Manual: Knock Sensor
Component Inspection
Component Inspection
-
CHECK KNOCK SENSOR
-
Turn ignition switch OFF.
-
Disconnect knock sensor harness connector.
-
Check resistance between knock sensor terminals as follows.
Note:
It is necessary to use an ohmmeter which can measure more than 10 MΩ.
Knock sensor
Condition
Resistance
Terminal
1
2
Temperature
20°C (68°F)
532 – 588 kΩ
CAUTION:
Never use any knock sensors that have been dropped or physically damaged. Use only new ones.
Is the inspection result normal?
YES >>INSPECTION END
NO >>Replace malfunctioning knock sensor. Refer to Exploded View.
-
Other materials:
Warning/Indicator lights (other)
For additional details about warning and indicator functions in the Nissan Sentra,
refer to the sections titled "Vehicle information display 4.2 inch (11 cm) Type
A" or "Vehicle information display 7 inch (18 cm) Type B", depending on the equipment
installed in your vehicle ...
Symptom Diagnosis
Rear Automatic Braking
Symptom Table
Symptom Table
CAUTION:
Perform the self-diagnosis with CONSULT before the symptom
diagnosis. Perform the trouble diagnosis if any DTC is detected.
Symptom
...
Ecu Diagnosis Information. Adas Control Unit 2
Adas Control Unit 2
Values on the Diagnosis Tool
Values on the Diagnosis Tool
Note:
The following table includes information (items)
inapplicable to this Nissan Sentra vehicle. For information (items) applicable to this
vehicle, refer to CONSULT display items.
...