Nissan Sentra manuals

Nissan Sentra Service Manual: AV branch line circuit

Diagnosis procedure

1.Check connector

  1. Turn the ignition switch off
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the av control unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector.

2.Check harness for open circuit

  1. Disconnect the connector of AV control unit.
  2. Check the resistance between the av control unit harness connector terminals.


Is the measurement value within the specification?


Is the measurement value within the specification? Yes >> go to 3.

No >> repair the av control unit branch line.

3.Check power supply and ground circuit

Check the power supply and the ground circuit of the av control unit. Refer to the following.

Is the inspection result normal? Yes (present error)>>replace the av control unit. Refer to the following.

Yes (past error)>>error was detected in the av control unit branch line.

No >> repair the power supply and the ground circuit.

Strg branch line circuit
Diagnosis Procedure 1.Check connector Turn the ignition switch off Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the steering angle sensor for ...

Bcm branch line circuit
Diagnosis Procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the BCM for damage, bend and ...

Other materials:

Precautions on supplemental restraint system
This Supplemental Restraint System (SRS) section contains important information concerning the following systems: Driver and passenger supplemental frontimpact air bag (NISSAN Advanced Air Bag System) Front seat-mounted side-impact supplemental air bag Roof-mounted curtain side-impac ...

Strg branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side). Is the inspection result ...

C1164, C1165, C1166, C1167 CV/SV System
DTC Logic Dtc detection logic DTC Display Item Malfunction detected condition Possible causes C1164 CV 1 When a malfunction is detected in cut valve 1. Harness or connector ABS actuator and electric unit (control unit) Fusible link Battery ...

В© 2014-2026 Copyright www.nisentra.com