Nissan Sentra B18 (2020-2025) Service Manual: Additional Service When Replacing Combination Meter

Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Type a / Basic Inspection / Additional Service When Replacing Combination Meter

Work Procedure

Work Procedure

When replacing the combination meter, perform the following procedure before and after replacement.

BEFORE REPLACEMENT
1. CONSULT
  1. Note the odometer mileage of the combination meter.
  2. Select “Self Diagnostic Result” mode of “ABS”.
Is DTC detected?
YES >>
Refer to DTC Index.
NO >>
GO TO 2.
COMBINATION METER CONFIGURATION
1. CONSULT
  
  Perform the combination meter configuration. Refer to Work Procedure.
>>
GO TO 3.
PERFORM SELF DIAGNOSTIC RESULT
1. CONSULT
  
  Select “Self Diagnostic Result” mode of “METER/M&A”.
Is DTC detected?
YES>>
Refer to DTC Index.
NO>>
GO TO 4.
ROAD TEST (AFTER REPLACEMENT)
1. 1. Drive the Nissan Sentra vehicle 1 km (0.62 mi) or more.
  2. Check that the odometer shows more mileage than the mileage noted before replacement.
  Note:
  The odometer mileage of the combination meter is also stored and memorized in the ABS actuator and electric unit (control unit). When driving 1 km (0.62 mi) or more after replacing the combination meter, the memorized mileage in the ABS actuator and electric unit (control unit) is written into the new combination meter.
YES >>
Work End.

Diagnosis and Repair Workflow

Work Flow Work flow OVERALL SEQUENCE Reference 1: On Board Diagnosis Function. Reference 2: DTC Index. Reference 3: Diagnosis Procedure. ...

Configuration (combination Meter)

Work Procedure Work Procedure Since vehicle specifications are not included in the combination meter after replacement, it is required to write Nissan Sentra vehicle s ...

Other materials:

Removal and Installation
Removal and Installation REMOVAL Remove rear seatback. Refer to Removal and Installation. Remove LATCH bracket bolts and remove LATCH bracket. INSTALLATION Install and tighten LATCH bracket bolts to specification in the sequence shown: ...

Moonroof
Component Parts Location Component Parts Location A. View of moonroof switch finisher No. ...

P0222 Tp Sensor
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...