Nissan Sentra B18 (2020-2025) Service Manual: Configuration (combination Meter)

Work Procedure

• Since vehicle specifications are not included in the combination meter after replacement, it is required to write Nissan Sentra vehicle specifications with CONSULT.

• Configuration has three functions as follows.

  Function		Description
  Read/Write Configuration	Before Replace ECU	Allows the reading of Nissan Sentra vehicle specification written in combination meter to store the specification in CONSULT.
  	After Replace ECU	Allows the writing of the Nissan Sentra vehicle information stored in CONSULT into the combination meter.
  Manual Configuration		Allows the writing of the Nissan Sentra vehicle specification into the combination meter by hand.

CAUTION:

• Use “Manual Configuration” only when “Parts number” of combination meter cannot be read.

• If an error occurs during configuration, start over from the beginning.

1. CHECKING PARTS NUMBER

   1. CONSULT

      1. Select “Before Replace ECU” of “Read/Write Configuration”.

      2. Check that “Parts number” is displayed.

   Is “Parts number” displayed?

   YES >>

   GO TO 2.

   NO >>

   GO TO 6.

2. VERIFYING PARTS NUMBER (1)

   1. CONSULT

      Compare a “Parts number” displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these “Parts number” agree with each other.

      Note:

      For the “Parts number” searched by using FAST (service parts catalog), use the last five digits of the “Parts number”.

   >>

   GO TO 3.

3. SAVING PARTS NUMBER

   1. CONSULT

      Save “Parts number”.

   >>

   GO TO 4.

4. REPLACE COMBINATION METER (1)

   1. Replace combination meter. Refer to Removal and Installation.

   >>

   GO TO 5.

5. WRITING (AUTOMATIC WRITING)

   1. CONSULT

      1. Select “After Replace ECU” of “Re/programming, Configuration” or that of “Read / Write Configuration”.

      2. Select the “Parts number” agreeing with the one stored on CONSULT and the one searched by using FAST (service parts catalogue) to write the “Parts number” into the combination meter.

   >>

   GO TO 8.

6. REPLACE COMBINATION METER (2)

   1. Replace combination meter. Refer to Removal and Installation.

   >>

   GO TO 7.

7. WRITING (MANUAL WRITING)

   1. CONSULT

      1. Select “Manual Configuration”.

      2. Select the “Parts number” searched by using FAST (service parts catalogue) to write the “Parts number” into the combination meter.

         Note:

         For the “Parts number” searched by using FAST (service parts catalog), use the last five digits of the “Parts number”.

   >>

   GO TO 8.

8. VERIFYING PARTS NUMBER (2)

   1. CONSULT

      Compare a “Parts number” displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these “Parts number” agree with each other.

      Note:

      For the “Parts number” searched by using FAST (service parts catalog), use the last five digits of the “Parts number”.

   >>

   GO TO 9.

9. OPERATION CHECK

   1. Confirm that each function controlled by combination meter operates normally.

   >>

   Work End.

© 2014-2026 Copyright www.nisentra.com