Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Dtc/circuit Diagnosis / P0641 Sensor Power Supply

Nissan Sentra B18 (2020-2025) Service Manual: P0641 Sensor Power Supply

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0641	Sensor reference voltage A (Sensor reference voltage “A” circuit open)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	—
		Threshold	When an input voltage of sensor reference is not 3.3 V.
		Diagnosis delay time	—

POSSIBLE CAUSE

Electric IVT control module

FAIL-SAFE

Engine Control System

Engine operating condition in fail-safe mode
Fail safe mode		Nissan Sentra Vehicle behavior
Device fix mode		This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position. The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).
Combustion control mode	Stratified charge combustion control at starting	No stratified charge combustion at starting (cold start).
	Idle speed control	Stops feedback control of idle speed and controls with specified speed.
	Recovery speed control at decelerating	Stops recovery speed control by the fuel cut at decelerating and controls with specified speed.
	Idle neutral control	Stops idle neutral control.
Others		ECM stops the electric valve timing control. (The camshaft returns to the position of most retard angle.)

Idle Start/Stop System

When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited.

When ECM detects error while operating the idle start/stop system, ECM restarts the engine.

Confirmation Procedure

Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON and wait at least 5 seconds.
2. Check DTC.
Is DTC P0641 detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO-1 >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>
Confirmation after repair: INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK ELECTRIC IVT CONTROL MODULE POWER SUPPLY AND GROUND CIRCUIT

Check electric IVT control module power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?
YES >>
Replace electric IVT control module. Refer to Removal & Installation.
NO >>
Repair or replace error-detected parts.

 P062f Ecm

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P062F 00 CONTROL MODULE (Internal control module...

 P0643 Sensor Power Supply

Dtc Description DTC Description ECM supplies a voltage of 5 V to some of the sensors systematically divided into 2 groups, respectively. Accordingly, when a short circuit develo...

Other materials:

Exhaust System. Removal and Installation. Exhaust System
Exhaust System Exploded View Exploded View 1. Mounting rubber 2. Heated oxygen sensor 2 3. ...

Frp Control System
Component Inspection Component Inspection CHECK HIGH PRESSURE FUEL PUMP-1 Turn ignition switch OFF. Disconnect high pressure fuel pump harness connector. Check the resistance between high ...

Trunk Lid
Exploded View Exploded View 1. Trunk lid weather-strip 2. Trunk lid hinge (LH) 3. ...