Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Dtc/circuit Diagnosis / P062f Ecm

Nissan Sentra B18 (2020-2025) Service Manual: P062f Ecm

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC		CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P062F	00	CONTROL MODULE (Internal control module EEPROM error)	Diagnosis condition	Engine running at idle
			Signal (terminal)	—
			Threshold	EEPROM (built-in microcomputer) system internal ECM does not function properly
			Diagnosis delay time	—

POSSIBLE CAUSE

ECM

FAIL-SAFE

Not applicable

Confirmation Procedure

Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  
  TESTING CONDITION:
  
  Before performing the following procedure, confirm that battery voltage is between 11 V or more with ignition switch.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON and wait at least 1 second.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Repeat step 1 and 2 for 10 times.
4. Erase DTC
5. Turn ignition switch OFF and wait at least 10seconds
6. Turn ignition switch ON
7. Check the DTC.
Is 1st trip DTC detected?
YES >>
INSPECTION END
NO >>
Refer to DTC Diagnosis Procedure.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

INSPECTION START
1. Turn ignition switch ON and wait at least 1 second.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Repeat step 1 and 2 for 10 times.
4. Erase DTC.
5. Turn ignition switch OFF and wait at least 10 seconds.
6. Turn ignition switch ON.
7. Check the DTC.
Is DTC erased?
YES >>
INSPECTION END.
NO >>
GO TO 2.
REPLACE ECM
1. Replace ECM. Refer to ECM : Removal & Installation.
2. Refer to Work Procedure.
>>
INSPECTION END

 P062d Ecm

Dtc Description DTC Description This DTC is detected when the ECM-integrated injector driver unit has a malfunction. DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagno...

 P0641 Sensor Power Supply

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0641 Sensor reference voltage A (Sensor referen...

Other materials:

P1197 Out of Gas
Dtc Description DTC Description This diagnosis result is detected when the fuel level of the fuel tank is extremely low and the engine does not run normally. DTC DETECTION LOGIC DTC ...

Front Brake Caliper Assembly
Exploded View Exploded View 1. Brake caliper body 2. Bleeder valve 3. ...

Fuel Level Sensor Signal Circuit
Component Function Check Component Function Check COMBINATION METER INPUT SIGNAL CONSULT Select “FUEL METER” in “Data Monitor” mode of “METER/M&A”. Compare the ...